Draytek Vigor2862 Series, Руководство пользователя

Страница: 973 / 988

Vigor2862 Series User’s Guide 957
1: Active-Standby
0: Hot-Standby
-v <1-255> Specify the group ID (VHID)
1- 255: Setting range.
-R Set HA settings to Factory Default.
-p <1-30> Specify the Priority ID.
1-30: Setting range.
-k <key> Specify the Authentication Key.
Key: Max. 31 Characters.
-u <1/0> Enable or disable the function of Update DDNS.
1: Enable. When a router changes HA status to primary, it will
update DDNS automatically.
0: Disable.
-m <interface> Specify the management interface.
Interface: LAN1 ~ LAN6, DMZ.
-s It means to get the newest status of other router (except the local
router).
-y
It means sync local config to other router. Primary can executes this
command. Secondary can not execute this commad.
-c <1/0> Enable or disable the function of Config Sync.
1: Enable.
0: Disable.
-I -[M|H|D] <interval> Set the Config Sync Interval for HA. Minimum interval is 15 minutes.
-M: Minute. Setting range is 0/15/30/45. (e.g., ha set -I -M 30)
-H: Hour. Setting range is from 0 to 23. (e.g., ha set -I -H 12)
-D: Day. Setting range is from 0 to 30. (e.g., ha set -I -D 15)
-h -<4/6><Subnet> [<Virtual
IP>] Enable and set virtual IP to the subnet.
4: IPv4; 6: IPv6.
Subnet: LAN1 to LAN6, DMZ.
Virtual IP: The type format shall be “xxx.xxx.xxx.xxx”. (e.g,
192.168.1.0)
For example, to enable a virtual IP to the sunet, simply type:
ha set –h LAN1 192.168.1.5
-d -<4/6><Subnet> Disable a virtual IP to the subnet.
4: IPv4; 6: IPv6.
Subnet: LAN1 to LAN6, DMZ.
For example, to disable a virtual IP to the subnet, just type:
ha set –h LAN1
-o <1/0> Run DARP protocol on IPv4 or IPv6.
0: IPv4
1: IPv6
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> > ha set -h -4 LAN1 192.168.1.1
% Enable IPv4 Virtual IP on LAN1
% Virtual IP can not be same as router IP (192.168.1.1)!!!
>
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
h
h
a
a
s
s
h
h
o
o
w
w
This command can be used to show the settings information about config sync and general
setup.