Draytek Vigor2862 Series, Руководство пользователя

Страница: 901 / 988

Vigor2862 Series User’s Guide 885
0 map to 0dB
1 map to -0.3dB .... 100 map to -30dB
voip dsp cwtonepwr
ch Set the call waiting tone power level.
1 – FXS 1
2 – FXS 2.
value 1 ~ 30, in -1 dB increments, with 1 corresponding to 8 dBm.
voip dsp pstnringfxs
1|2 Enable or disable PSTN ring on FXS 1/FXS 2.
1 meansFXS1; 2 means FXS2.
on|off On means enable; off means disable.
voip dsp relaydbounce
on|off on: Enable relay filter noise. But it maybe ignore the caller-id!!!
off: Disable relay filter noise. But the noise will cause the relay to
switch to PSTN!!!
voip dsp setRingPat
ring_pattern_index This command can change the ring pattern at Index(2)~Index(6).
ring_pattern_index – Index (1) was locked for your country.
patten_num It's the ring pattern number (1~12) for a country.
--------------------------------------------
patten_num=1 Australia Ring Pattern:
cadenceOneOn=400, cadenceOneOff=200
cadenceTwoOn=400, cadenceTwoOff=2000
patten_num=2 Denmark Ring Pattern:
cadenceOneOn=1000, cadenceOneOff=4000
………………………………
voip dsp setFaxECmode -s
ch Set the FAX error correction mode.
ch : range (0 ~ 1)
mode mode : EC(error correction) ch(x) mode(0) : REDUNDANCY
EC(error correction) ch(x) mode(1) : FEC
voip dsp setDtmfCidlevel –l / voip dsp setDtmfCidlevel –h [value]
voip dsp setDtmfCidlevel –r 0
value “setDtmfCidLevel” is used to configure the signal strength for
transferring to FXS DTMF caller ID.
value - 0 ~ 64
voip dsp setDtmfCidLevel -l [value]
voip dsp setDtmfCidLevel -h [value]
voip dsp setDtmfCidLevel -r 0/1
r - reset low/high DTNF level to default setting. 0 means Disable; 1
means Enable.
Note: This function is supported only by special mode.
voip dsp setfxoCY
value It is used to apply FXO country settings.
0: "use system country"
1: "Taiwan"
2: "Germany"
3: "Sweden"
4: "France"
5: "Switzerland"