38
5.3.2.
Editing a log diameter
Log diameters that are too large or too small can be adjusted. To do this, click on the inside
of the circle of the respective log. All other diameters will be hidden and the one to be edited
will appear in green (see Figure 24).
Figure 25: Representation of a selected diameter for editing
If you move the pen up and out of the circle on the monitor, the circle increases in size, move
the pen down, the circle reduces in size.
After editing, click anywhere outside the circle to see all diameters again.
By clicking and holding a diameter, you can also move it to any position.
NOTE:
Make the pen movements slowly to allow delicate adjustment.
NOTE:
If you move the pen diagonally across the monitor, the circle is only changed by the respective
vertical component of the movement.
Содержание sScale
