DRALLE sScale, Руководство пользователя

Страница: 38 / 52

32
By pressing the button 2.2.4.4 “Search” you can search for a specific woodpile. A keyboard
appears on which you can enter the corresponding woodpile number.
5.1.3. User
By pressing the button 2.2.2.8 “User” you reach the sub- menu “User”. A list of all possible
system users created on the server is displayed. Search for the suitable user in the list and
click on this to save it to the next user choice in the system and to internally assign the
produced measurement results to the selected user.
The selected user appears on the user interface “Result” (see Chapter A.2.2.7, point 3) Fur-
thermore, this information is also transmitted to the customer server together with the meas-
urement results.
5.1.4. Network status
By pressing the button 2.2.2.9 “Network status” you reach the sub - menu “Network status”.
Here you can see if there are still any measurements on the system that have not yet been
transmitted to the customer server.
NOTE:
The measurement results are stored in the archive immediately after completion of the meas-
urement and only then sent to the server. Even if the system is shut down with measurements
that have not yet been sent, this data will not be lost.
Sending the results to the sScale ™ server may take so me time, depending on your network
connection.
5.1.5. Light
By pressing the button 2.2.2.10 “Light” you can switch the built -in LED floodlight on and off
again. This is especially helpful at night when you want to detect sprayed woodpile numbers.
If you use the light during a measurement, the floodlight acts as a flash. These flashes are
significantly brighter than the steady lights and are synchronised with the exposure of 10 ms.
CAUTION:
The floodlight is very bright in the flash mode! Do not look directly into the floodlight!
CAUTION:
Please note that the floodlight must not be in operation when driving on public roads!
Consider other road users when taking measurements in the vicinity of public roads at night.
To avoid endangering them by glare, only leave the floodlight on for as long as you need its
light.
5.1.6. Demo
By pressing the button 2.2.2.11 “Demo” you reach the sScale™ demo mode. The system is
restarted and the picture sequence of an internal demonstration woodpile is loaded. The sys-
tem can be used and demonstrated normally, but the measurement already starts at Chapter
3.2.2. With the “Discard” of a demo measurement or the “Submit”, the normal measurement
mode of the sScale™ restarts.