Dräger 84 13 050, Руководство по эксплуатации

Страница: 23 / 68

Tests of Readiness for
Operation
MicroVent Checklist
23
Operating Instructions MicroVent
What How Required
Actual
Breathing system
Expiratory valve, flow sensor with
elbow connector, temperature sensor,
thermometer
connected
check off for
"Pass"
___________
circuit, water traps, humidifier all complete and properly in place
___________
Electrical sypply
Disconnect from line power;
disconnect probe for O
2
and Air.
Self-test,
Display:
Intermittent audible alarm, yellow sta-
tus light is lit, red status light flashing.
___________
Press
g
key.
Display:
___________
Connect to line power green status light is on
___________
Gas supply
Connect probes for O
2
and air; switch
to CMV mode
after about 15 seconds,
new display:
Intermittent audible alarm, red status
light flashing
___________
Ventilation and
check for leaks
Connect test lung.
Intermittent audible alarm stops,
red status light off.
___________
f = 10 bpm, V
T
= 0.5 L, T
insp.
= 2 s,
P
max
= 50 cmH
2
O,
MV Y low = 2 L/min,
MV Y high = 10 L/min,
PEEP = 5 cmH
2
O, PS = 0 cmH
2
O
Display:
±
1L/min
___________
Take PEEP reading on pressure gauge PEEP = 5
±
2 cmH
2
O
___________
Monitoring MV Y low = 7 L/min
Display:
Intermittent audible alarm, red status
light flashing
___________
MV Y high = 3 L/min
Display:
Intermittent audible alarm, red status
light flashing
___________
P
max
5 cmH
2
O below ventilation
pressure
Display:
Intermittent audible alarm, red status
light flashing
___________
MV Y low = 0 L/min,
MV Y high = 20 L/min
___________
Humidifier
Test according to its
Operating Instructions
___________
No ventilation
Power failure
No ventilation
Supply press. low
Meas. value MV = 0
Paw low
MV = 5 L/min
I:E = 1:2
MV = 5 L/min
MV high
MV = x.x L/min
Paw high
MV = 5 L/min
MV low
NOTE: A copy of this checklist is pro-
vided on a plastic card. Keep it with
the ventilator and use for checks
before each use of the ventilator