DR 30.00 COMMERCIAL RAPID-FEED CHIPPER, Руководство по безопасности и эксплуатации

Страница: 55 / 80

CONTACT US AT
www.DRpower.com
or CALL TOLL FREE
1-800-DR-OWNER
51
CHAPTER 7
CHIPPER ACCESSORIES
SHUT DOWN THE ENGINE, WAIT FOR ALL MOVING PARTS TO COME TO A COMPLETE STOP,
REMOVE SPARK PLUG WIRES, DISCONNECT THE NEGATIVE BATTERY CABLE, THEN WAIT 5 MINUTES
BEFORE PERFORMING ANY MAINTENANCE PROCEDURE, ADDING OPTIONAL ACCESSORIES OR
INSPECTION ON THE CHIPPER.
Extended Top-Discharge Chute
The Extended Top-Disc n of the discharged chips
irec
:
re
INSTA
o Bolts a s from the Low
Discharge Assemb
45 ).
2. Remove the Low D
Chipper.
e Extended
h the Locking Pin on the outside (side
hest away from
o Bolt
nches.
p-Disc n of the discharged chips
irec
:
re
INSTA
o Bolts a s from the Low
Discharge Assemb
45 ).
2. Remove the Low D
Chipper.
e Extended
h the Locking Pin on the outside (side
hest away from
o Bolt
nches.
harge Chute enables you to better control the directio harge Chute enables you to better control the directio
and allows you to d and allows you to d t them into a trailer or truck bed for transport. t them into a trailer or truck bed for transport.
Tools Needed Tools Needed
•
Two 1/2" W
•
Two 1/2" W nches nches
LLATION
1. Remove the tw
LLATION
1. Remove the tw nd Locknut nd Locknut
ly with two 1/2" wrenches ( Figure ly with two 1/2" wrenches ( Figure
ischarge Assembly from the ischarge Assembly from the
3. Position th
Chipper wit
furt
3. Position th
Chipper wit
furt
Top-Discharge Chute onto the Top-Discharge Chute onto the
the hopper) ( Figure 46 ). the hopper) ( Figure 46 ).
4. Install the tw
two 1/2" wre
4. Install the tw
two 1/2" wre
s and Locknuts and tighten with s and Locknuts and tighten with
Low
Discharge
Assembly
Figure 45
Bolt and
Locknut
Extended Top-
Discharge Chute
Figure 46
Locking
Pin
Bolt and
Locknut
(2 places)