DR 30.00 COMMERCIAL RAPID-FEED CHIPPER, Руководство по безопасности и эксплуатации

Страница: 49 / 80

CONTACT US AT
www.DRpower.com
or CALL TOLL FREE
1-800-DR-OWNER
45
End o
-s res.
•
•
If your DR RAPID-FEED CHIPPER will be idle for more than 30 days, we recommend using a gas
p retor. If there is dirt or moisture
ompletely fill the tank with fresh, unleaded gas
unt of stabilizer or gasoline additive. Run the engine for a short time to
w and
leakage.
ve the spark plugs and pour about 1 ounce of motor oil into each cylinder hole. Reinstall the
ldup.
•
s, blower housing, debris screen and
•
•
tery or store your DR RAPID-FEED CHIPPER in a dry environment where the
temperature is between –10° F (–23° C) and +85° F (+23° C). Make sure the storage temperatures
•
SH ARTS TO COME TO A COMPLETE STOP,
REMO ATTERY CABLE, THEN WAIT 5
MINUTES BEFORE PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION ON THE
CH P
•
NEVER STO THE FUEL TANK INSIDE A BUILDING
W R S HOT WATER AND SPACE HEA
CLOTHES DRYERS AND THE LIKE. IF YOU ARE GOING TO DRAIN THE FUEL TANK, DO THIS
O
TORING IN ANY ENCLOSURE.
•
WHEN NOT IN USE, YOUR DR RAPID-FEED CHIPPER SHOULD BE STORED OUT OF THE REACH
O
H
f Season and Storage
UT DOWN THE ENGINE, WAIT FOR ALL MOVING P
VE SPARK PLUG WIRES, DISCONNECT THE NEGATIVE B
IP ER.
RE THE DR RAPID-FEED CHIPPER WITH FUEL IN
HE E IGNITION SOURCES ARE PRESENT, SUCH A TERS,
UTDOORS. ALLOW THE ENGINE TO COOL BEFORE S
NOTE: Please refer to the Engine Owner's Manual for engine
Change the oil (and oil filter, if applicable).
F C ILDREN.
cific procedu pe
stabilizer. This will prevent sediment from gumming u
in the gas or tank, remove it by draining the tank. C
and add the appropriate amo the carbu
allow the additive to circulate. Close the fuel Shut-Off Valve to prevent carburetor overflo
•
Remo
plugs and engage the electric starter for a few seconds. This will coat the pistons and seat the valves
to prevent moisture bui
•
Clean or replace the air filter(s).
Lubricate all grease fittings.
•
Clean any dirt and debris from the cylinder head cooling fin
muffler area of the engine.
If your engine has a fuel filter, replace it.
Check the Drive Belt for wear.
•
Check the Chipper Knife and Wear Plate for nicks and wear.
•
Remove the bat
will never be outside these limits.
•
Clean any debris from the Hopper and Discharge Chute.