DPtech FW1000 Series Firewall Products User Configuration Guide
3-73
3.8 Autoconfig
3.8.1 Stateless configuration
To enter the stateless configuration page, you can choose
Basic> Network > Stateless configuration
, as shown in
Figure3-37
Stateless configuration
3.9 IPv4 unicast routing
3.9.1 IPv4 unicast routing
IPv4 unicast routing allows you to configure IPv4 static routing manually. After you configured IPv4 static routing,
data packets will be transmitted to the destination according to your requirement.
3.9.2 Configure static route
3.9.2.1 Introduction to static route
Static route is a kind of special route that configured by administrator manually. After static route is configured, data
packets go to the specific destination will be forwarded to the paths designated by administrator.
In a simple network, network communication can be realized only by configure the static route. If you set and use
static route properly, it can improve the network performance and guarantee bandwidth for important applications.
When you configure static route, you should understand the following:
1. Destination IP address and mask
When you configure static route, destination IP address and mask must be in dotted decimal notation format.
2. Outbound interface and next hop
When you configure static route, you can specify the outbound interface and next hop. Whether you specify the
outbound interface or next hop, you should depend on the real condition. Routing cannot take effect if the next hop
is local interface IP address.
