48
You can view the calibration progress in the D-Wire Sensors Monitor page.
The first part of the calibration should display the qual percentage, followed by the calibration
percentage.
Once calibration finishes, same air flow should result in 100%.
2.15.2
D-Wire Sensors (Optional)
Fig. 2.28.
D-Wire Sensors menu
If this NetGuardian G5 has support for D-Wire sensors, a link will appear in the
Edit
menu sidebar. The
interface will resemble the
Edit
>
Base Analogs
menu, but with two new columns:
ROMID
and
Freq.
Any detected or configured sensor will automatically fill out a ROMID cell. The color of each cell will
signify its configuration status: If the ROMID cell is yellow, the sensor is detected but is not yet
configured. If the cell is red, then the sensor is configured but has not been detected, and the "D-Wire
Sensor Not Detected" System Alarm will set. The "Unit" field will automatically be configured upon
submission, no changes should be made to this field for D-Wire sensors. The
Freq.
column
determines how often (in minutes) the unit logs each sensor to a .csv file.
Note
: The page must be submitted in order to configure the detected
ROMID(
s). It may take up to one
minute for a newly attached sensor to register in the
Edit
or
Monitor
interface.
Содержание NetGuardian 832A G5
Страница 132: ...127...