44
Configuring Ping Targets
2.14
Fig. 2.25.
Configure the ping target parameters from the Ping Info screen
Each of the 32 ping targets can be provisioned with a description, an IP address, primary and secondary
notification devices, and an option to verify connection using SNMPv1 GET. The NetGuardian G5 will
issue a call to the primary notification device followed by a call to the secondary notification device in the
event a ping alarm occurs.*
Use the following steps to configure the ping targets:
1. From the
Edit
menu select
Ping Targets
, see Figure 2.25.
2. In the
Description
field, enter a description of the device to be pinged.
3. In the
IP Address
field enter the IP address of the device to be pinged.
4. Under the
Trap
column check the box to designate that an SNMP trap will be sent when an alarm
condition exists. Leaving the box blank designates that an SNMP trap will not be sent when an alarm
condition exists.
5. Set the primary and secondary pagers with a pager ID from your defined pager list. (See Section
"Setting up Notification Methods" for more information.)
Note:
The NetGuardian G5 will notify both the primary and the secondary notification device when
point status changes (both alarm and clear).
6. Under the
Group
column enter the appropriate point group ID, see section "Defining Point Groups."
7. Under the
SNMP
column check the box to enable pinging of the device using SNMPv1 GETs instead
of traditional ICMP. If the box is not checked, the device will be pinged using traditional ICMP.**
8. Select the OID to retrieve with the SNMP GET. The following is a list of available MIB variables in the
System OID
field:**
sysDescr, OID .1.3.6.1.2.1.1.1.0
sysObjectID, OID .1.3.6.1.2.1.1.2.0
SysUpTime, OID .1.3.6.1.2.1.1.3.0
9. In the
Community
field enter the community string for the SNMP GET request.The community string
must match the community string configured in the target device.**
10. Click
Submit Data
to save the configuration settings.
*See Section 'Setting System Timers' to set ping response and fail times.
**
Note:
The following field options are only available with firmware version 5.1 D or higher.
Содержание NetGuardian 832A G5
Страница 132: ...127...