DP Pumps Hydro-Unit Premium Line F, Инструкция по установке и эксплуатации

Страница: 55 / 64

55 / 64
A B C D E F G H I J K L Possible cause
Remedy
6)
✘ - - ✘ ✘ - - - - ✘ - - Start-up pressure set too high Check setting.
- ✘ - - ✘ ✘ - ✘ - ✘ - ✘ Pressure transmitter set incorrectly or
defective
Check setting.
- - - - - - - ✘ - - ✘ ✘ Pre-charge pressure of the accumulator
too low
Restore nitrogen cushion.
- - - - - - - ✘ - - ✘ ✘ Defective accumulator Check integrity/replace, if necessary.
- - - - - - ✘ - - - - - Defective mechanical seal Replace.
✘ - - - - - - ✘ - ✘ - - Suction-side pressure switch set
incorrectly or defective Check setting.
- - ✘ ✘ ✘ - - ✘ ✘ ✘ ✘ - Defective check valve in the pressure
booster system Check, replace sealing element as
necessary.
- - - - ✘ - - - ✘ ✘ - ✘ Water extraction higher than stated in
the purchase order
Contact KSB.
- ✘ - - - - - - ✘ - - ✘ Motor protection switch triggered or set
incorrectly, or pump seized
Compare setting with the motor's rating
plate data.
- - - - - - - - - - ✘ - Delay setting too short Check setting.
- ✘ - - - - - - - - - - Mains supply interrupted Check and remedy defect/check fuse.
- ✘ - - - - - - - - - - Control current fuse tripped (control
cabinet) Determine cause and reset.
- ✘ - - - - - - ✘ - - - Main fuse on (owner-supplied)
distribution board loose or blown; fuses
possibly too small or too fast Check fuses and replace as necessary.
Measure the motor current.
- - - - - - - - ✘ - - - Intermittent voltage fluctuations Press reset and fault acknowledgement
key.
- ✘ - - - - - - - - - - Phase failure Check individual phases; replace fuse,
if necessary.
✘ - - - - - - - - - - - Inlet tank empty or float switch
defective / disconnected Check and remedy defect.