Setting the material flow
Fig. 3: Setting the material flow
1. Set the material flow.
Turn material flow control (1) in
required direction.
Right turn: less material
Left turn: more material
Do not turn material flow control
to the right up to the mechanical
stop. The needle can then no
longer move properly.
To reduce the material quantity,
preferably use a smaller nozzle
set and not the material quantity
control.
To increase the material quantity,
preferably use a larger nozzle set.
Set total air pressure
Fig. 4: Setting the total air and horn air pres-
sure
2. Set the total air pressure by turning the
total air control (2).
Right turn: Lower total air pressure
Left turn: higher total air pressure
Observe the following character-
istic curve.
Setting the horn air pressure
3. Set the horn air pressure by turning the
flat jet control (1).
Right turn: rounder spray pattern
Left turn: flatter spray pattern
You can turn the flat jet control
continuously and adjust the spray
pattern from flat to round jet.
Characteristic curves
The characteristic curves show the air flow
rate for various nozzle sets and air caps for
different air pressures.
Commissioning
05/2018
EcoGun 116 - MSG00017EN
9/44
