6100 Series Industrial End Drive Conveyors Installation, Maintenance & Parts Manual
Dorner Mfg. Corp.
15
851-268 Rev. F
2
.
Remove two clips (AX).
3
.
Install bolt (part # 906-278
k
) (BA of Figure 38) into
bearing sleeve(s) (AY). Remove bearing sleeve(s)
(AY).
NOTE:
If retaining sleeve (AY of Figure 38) does not
slide out:
D
Remove tail following steps 3, 4 & 5 of Removal
of Drive Pulley with Standard 0.47¨ (12 mm)
Diameter Output Shaft on page 13
D
Assemble pulley (AZ of Figure 39), removal tool
(part # 25-09
k
) (BB), and bolt (part # 906-278
k
)
(BA), as shown
D
Tighten bolt (BA) to remove bearing sleeve (AY)
Figure 39
AZ
BB
BA
Bearing Replacement for Drive Pulley with
Standard 0.47¨ (12 mm) Diameter Output Shaft
or Idler Pulley
IMPORTANT:
Once removed, do not re-use
bearings.
Bearing Removal
1
.
Place bearing removal tool (part # 450281) over
bearing(s) with lip (BD of Figure 40) located in
Bearing gap (BE) as shown.
Figure 40
BD
BE
2
.
Using 3/16¨ hex key wrench (BC of Figure 41),
tighten tool.
Figure 41
BC
3
.
Using a puller (BF of Figure 42), remove and discard
bearing(s).
Figure 42
BF
Bearing Installation
IMPORTANT:
I
nstall bearings one at a time.
1
.
Inspect seating surface(s) for damage. Replace if
damaged.
2
.
Slide bearing (part # 802-121) (BG of Figure 43) onto
pulley shaft.
Figure 43
BG
k
- Part of Tool Kit, part # 2500M.
Preventive Maintenance and Adjustment
Preventive Maintenance and Adjustment
