Determine the firmware variant (E3xx) and version.
The system level is shown under SL.
Under BLE, a check mark shows that BLE is active.
The system level is supported by the components and host systems from the following
versions.
The component can only be configured if the system level of the component and the
configuration file are the same.
The component can be configured if the system level of the component is higher than the
system level of the host system (Applies to SL1 to SL3. Does not apply to SL4).
A firmware update is also possible if the system level is incorrect.
Host system
from version Remarks
Exos
4.0.80
KEM
5.3
Matrix
3.4
evolo smart
2.0
exivo
EACM
7.6
B-COMM
3.18.0
Programmer 1460
1.26
The Programmer compares the system level of the
parameter file with the system level of the component.
Component (firm-
ware version)
42.28
In the factory, the system level is set according to the
order.
Update to a higher system level
The components are dispatched from the factory with a certain system level. If certain
functions are to be used, which are not released in that system level, then the system level of
the component has to be updated as required. Update media can be obtained for this
purpose.
The following media for updates/additional licences
Update
SL1 to SL2
Update
SL2 to SL3
Update
SL1 to SL3
Licensing
Mobile Access via BLE
The update procedure is described in the technical manual of the component.
To save time and money, order new components in the matching combination and
configuration.
Programming
User Manual
28
- 06/2021
dormakaba Programmer 1460
