![background image](http://html.mh-extra.com/html/ims/lcic-bat/lcic-bat_re-programming-manual_2049872001.webp)
1
Programming the DSP
24 June 14
Introduction
The usual burning (programming) procedure is the 14 steps described on pages 1-5.
Appendix
A
is required only in case your PC's COM1 is not available for RS232
communication.
Appendix
B
is required only in case your USB-to-Serial adapter was placed by the
system at COM5 or higher.
Appendix
C
is required only in case you want to check whether your PC is able to
implement the burning process faster.
Burning Procedure
1. Put the firmware file to be burnt in the proper path:
Recent firmware files are available in IMS site and/or on your CD,
under the folder:
LCIC-WIM -
xxx
\
LCIC-WIM -
xxx
- Board_Firmware_Update-Up-to-date_Version
(
xxx
is the specific type of your board)
For example,
LCIC-WIM -
WiM-mode
\
LCIC-WIM -
WiM-mode
- Board_Firmware_Update-Up-to-date_Version
Copy this folder to your hard disk, let's say under disk C:
C:\
LCIC-WIM - WiM-mode\
LCIC-WIM - WiM-mode - Board_Firmware_Update-Up-to-date_Version
Copy the file to be burnt (for example, LCIC3.121.out) to the folder
"
C:\CCStudio_v3.1
" and rename it to LCIC.out.
For example:
a. If the file C:\CCStudio_v3.1\LCIC.out' exists, then delete it.
b. Copy the file LCIC_3.121.out
from
C:\
LCIC-WIM - WiM-mode\
LCIC-WIM - WiM-mode - Board_Firmware_Update-Up-to-date_Version
to
C:\CCStudio_v3.1
.
c. Rename
C:\CCStudio_v3.1\LCIC_3.121.out
to
C:\CCStudio_v3.1\LCIC.out
C:\CCStudio_v3.1\LCIC.out
will be the file to be burnt by the SDFlash utility.
Содержание LCIC-BAT
