5.4.6 Info for TouchGo components (signal strength)
The menu is only displayed on the programmer if TouchGo actuators are recognised.
1.
Press the Import menu button.
ð
The Import menu opens.
2.
Select the Info menu.
3.
Press the ENTER button.
4.
Connect the programmer to the TouchGo actuator.
5.
Navigate to the UID, SNR and RSSI points in the menu using the DOWN button.
6.
Press the middle menu button and at the same time touch the door handle.
ð
The measurement starts.
5.4.6.1 Analysis of measurements
During the measurement of signal strength, a TouchGo medium must be carried in the (front)
trouser pocket, and the door handle must be touched with a hand to close the signal path.
Remove the USB cable during the measurement.
Sym-
bols
Causes
Unable to receive a signal.
– Major interference
– The transponder is defective or not available
– The door handle is not being touched, or the
installation is deficient
Increased interference within the en-
vironment.
– Increased level of interference within the en-
vironment
– The transponder is not being carried correctly
A weak signal is being received.
– Deficient installation
– The transponder is not being carried correctly
or its batteries are nearing the end of their use-
ful life
– Possible restrictions due to building
The use of TouchGo is possible
without restriction.
Explanation of the values:
5
The SNR value specifies the reception quality of the TouchGo transponder signal. A suffi-
ciently high signal quality is essential for TouchGo to function without restriction. The
RSSI value displays the total signal strength received. High RSSI values indicate sources
of interference in the immediate vicinity and reduce the functionality of TouchGo.
Programming
User Manual
34
- 06/2021
dormakaba Programmer 1460
