DORIC CLED, Руководство пользователя

Страница: 23 / 27

Table 5.2: General specifications for LED Drivers
SPECIFICATION VALUE NOTE
Power supply 110 - 240 VAC; 50 - 60 Hz Power supply adapter included
DC power supply 12 VDC 20 W (1-ch, 2-ch), 60 W (4-ch)
Mass
1-channel model 580 g (1.28 lbs)
2-channel model 757 g (1.67 lbs)
4-channel model 1155 g (2.55 lbs)
Dimensions (L x H x D)
1-channel model 17,5 cm x 5,0 cm x 10,5 cm Including connectors
2-channel model 23,4 cm x 5,0 cm x 10,5 cm Including connectors
4-channel model 3,5 cm x 5,0 cm x 10,5 cm Including connectors
TTL input voltage 0 to +5 V Hi Level
>
2.8 V; Low Level
<
2.3 V
Analog input voltage 400 mA/V light source current Normal Mode 2000 mA LED Driver
40 mA/V light source current Low current mode (*)
Analog input voltage range Min: 0.1 V Max: 5 V 40 to 2000 mA
4 to 200 mA (low-current mode (*))
BNC output voltage 0.0025 V/mA
Maximum output current range 200, 2000 mA
Maximum forward voltage to LED 7 V
Minimum output current 40 mA CW, Normal Mode
4 mA CW, Low current mode (*)
Display current accuracy 2% @ maximum rated current Error increases at lower current.
Current adjustment steps 1 mA
Rise/Fall time
<
10 µs Typical
Modulation minimum frequency 0.01 Hz
2
Internal complex mode : 0.000054 Hz
Modulation maximum frequency 50 kHz -3 dB attenuation
Minimum ON or OFF time 0.005 ms 2 Internal complex mode : 2 ms
Maximum ON or OFF time 100 s
2
Internal complex mode : 5 h
Maximum number of pulses per sequence 16.68 millions
2
Internal complex mode : 65 535
Maximum number of sequences 4.2 billions
2
Internal complex mode : 65 535
Minimum step increments 39 µsec
2
Internal complex mode only
Number of steps per period 128
2
Internal complex mode only
Scope acquisition speed 10 kS/s Single channel
Table 5.3: General Specifications for Connectorized LEDs
SPECIFICATION VALUE NOTE
Input Current Min: 0 mA - Max: 1000 mA Recommended 700 mA
Forward Voltage 3.0 - 4 V Typical
Dimensions 63 x 59 x 21 mm
3
Without cable, with baseplate
Mass
∼
100 g
CLED cable connector M8-4pins - Male See Fig. 5.1
Output NA 0.55 NA of up to 0.63 NA will slightly increase power;
Output Optical Fiber Core Diameter
<
960 µm Power scales up to this core diameter
Maximum Output Power See Datasheet Tested with 1 mm diameter core, 0.5 NA optical fiber
Figure 5.2: M8 Female Pinout (LED Driver)
Chapter 5. Specifications 23