V_1.OM.000160.DRM
Page 52
Version 5.0
Doremi Labs, Inc.
(type) VANC
Select standard VANC or Extended VANC.
(no.) bit audio
Select 16 bit or 32 bit audio.
DF/NDF
Select DF or NDF.
ICT
When the video is RGB 4:4:4, setting ICT to ON will perform a conversion
to YCbCr allowing to obtain a better JPEG2000 compression than RGB.
10.4 Init Disk
The Initialize Disk settings will set the parameters and configuration of the drive(s). These
settings are preconfigured at the factory (when the drives are purchased from Doremi Labs) and
typically will not require change.
You must initialize the drive(s) after changing any of the settings in this section.
MultiFile Type
This option indicates that the drive will be initialized with Doremi’s Multi-
File System (MFS). This setting cannot be changed.
Bus: (no.)
Select the number of SCSI buses to use. For internal drives bus 2 is used,
for external storage bus 1 is used, or when the external configuration
requires 2 buses then bus 1 and bus 2 are used.
#luns/ID(no.)
Select the number of luns. This parameter should be set to 1.
Stripe on: (no.)
Sets the number of disks in the RaidSets (see option below). This
parameter should be set to the total number of drives in the Raid set.
#RaidSets:(no.)
Sets the number of RaidSets to be defined. This parameter should be set
to 1.
Bus:1, id(no.)
Sets the first SCSI ID of bus 1. All other drive IDs for Bus 1 should be
consecutive to the first drive ID.
Bus:2, id(no.)
Sets the first SCSI ID of bus 2.
10.5 Save Setngs
This menu option will save all the current MENU settings of the V1 to the internal memory so
that upon restart the settings will be preserved. All saved settings will remain on the drive, so
that if the drive is placed in another V1 the settings will be preserved.
To write the settings to memory (Flash EPROM - see Note below), press
TOGGLE
. A message
will appear on the LCD screen: “Are you sure?”
♦
If you want to save, press
ENTER
. The V1 will write the changes on the Flash EPROM.
♦
If you change your mind and don't want to save, press
ESCAPE.
NOTE: THIS FUNCTION SHOULD NOT BE ABUSED BECAUSE THE FLASH EPROM CAN
ONLY BE WRITTEN 2000 TIMES. If you save your settings on the flash EPROM more
than 2000 times you might damage it and need to replace it by sending the unit back to
Doremi Labs.
