Doosan NHP10-425WCU-EU-FX-T3, Руководство по эксплуатации и обслуживанию

Страница: 41 / 88

Operating Instructions Operating & Maintenance Manual
37
Main Menu:
Displays a link to the following sub-menus:
1. User options: Displays the following options:
A. Pressure Setpoint: Press “SELECT” then adjust using the toggle up and
down buttons and pressing “SET”.
B. Auto ReLoad Pressure: Setpoint-140 psi (default).
C. Pressure Signal: Press “SELECT” then using the toggle up and down
buttons “SET” either Onboard or Remote.
D. Auto Start/Stop: OFF (default). Press “SELECT” then using the toggle up
and down buttons “SET” either PRESSURE or REMOTE.
E. Auto Re-Start Pressure: Auto Reload Pressure - 5 psi (default).
Selectable from default to 15 psi.
F. Auto Stop Time : 10 minutes (default). Selectable from 2 minutes to 60
minutes.
G. Screen Contrast : Press “SELECT” then adjust between 0 and 9 using the
toggle up and down buttons and pressing “SET”.
2. Sensor calibration : Displays the pressure transducers (PT1 through PT8) that
can be selected and calibrated using the “SELECT” and “CALIBRATE” buttons
(the unit must be completely cooled down so that all temperatures and
pressures are equivalent to ambient conditions).
3. Factory setpoints : Displays the selection options for language and units of
measure.
A. Compressor Status - Displays the following compressor sensor values:
1. Package Discharge Temp: Displays package discharge air temperature
measured at the service valve.
2. Package Discharge Pressure: Displays package discharge air pressure
measured at the service valve.
3. Stg 1 Inlet Temp: Displays airend stage 1 inlet temperature measured in
the inlet duct before the inlet valve.
4. Stg 1 Disch Temp: Displays airend stage 1 discharge temperature
measured in the venturi elbow.
5. Stg 1 Inlet Vacuum: Displays airend stage 1 inlet suction pressure
measured in the inlet valve.
6. Stg 2 Inlet Pressure: Displays the airend stage 2 inlet pressure measured
in the interstage moisture separator.
7. Stg 2 Inlet Temp: Displays the airend stage 2 inlet temperature measured
in the interstage moisture separator.