Doosan NHP10-425WCU-EU-FX-T3, Руководство по эксплуатации и обслуживанию

Страница: 33 / 88

Operating Instructions Operating & Maintenance Manual
29
Before Starting
Open service valves.
Inspect the complete installation including remote fuel lines (if any) and air hose routing and
connections.
Check battery for proper connections and condition.
WARNING
!
Combustible gas can cause severe burns, blindness or death. Keep
sparks and open flame away from battery.
• Check the compressor lubricating oil level. The proper oil level is labeled on the
compressor sump dipstick. Add oil when required. Do not overfill.
• Check the hydraulic oil level. The proper oil level is mid-way on the sight gauge. Add
oil if the level falls to the bottom of the sight gauge. Do not overfill.
• Check engine oil level. The proper level is labeled on the engine sump dipstick. Add
oil when required. Do not overfill.
• To jump-start, connect the positive booster/charger cable to the 24 VDC positive (+)
terminal of the battery. Then connect the negative booster/charger cable to the
engine block. Not to the negative (-) terminal of the weak battery. After starting,
disconnect the negative (-) cable from engine block; then from the booster
battery/charger. Disconnect positive (+) cable from both batteries.
WARNING
!
Do not remove the cap from a HOT engine radiator. The sudden release
of pressure from a heated cooling system can result in a loss of coolant
and possible severe personal injury.
WARNING
!
Hot pressurized fluid can cause serious burns. Do not open radiator while
hot.
Check coolant bottle to assure coolant level is at minimum level when the unit is cold.
Check engine coolant level by removing the radiator top cap and looking for coolant in the filler
neck of the radiator. Add coolant as required. Insure that radiator cap is installed properly and
tightened.