Doosan DL220, Руководство по эксплуатации и обслуживанию, Страница: 34 / 250

OP001012 Safety
1-22
Protection from Falling or Flying Objects
On work sites where there is a danger that falling or flying
objects may hit the operator's cabin select a guard to match the
operating conditions to protect the operator.
Working in mines, tunnels, deep pits or on loose or wet surfaces
could produce danger of falling rock, roll over or hazardous
flying objects. Additional protection for operator's cabin could be
required in form of a FOPS/Falling Object Protective Structure
and/or ROPS/Roll Over Protective Structure reinforcement
system.
Any reinforcement system that is installed on machine must
pass safety and certification standards and carry appropriate
labeling and rating information. For example, most often added
type of reinforcement system, FOPS, must meet or exceed
Society of Automotive Engineers standard SAE J1356,
"Performance Criteria for Falling Object Guards for Wheel
loaders."
Never attempt to alter or modify any protective structure
reinforcement system, by drilling holes, welding, remounting or
relocating fasteners. Any serious impact or damage to the
system requires a complete integrity reevaluation.
Reinstallation, recertification and/or replacement of the system
may be necessary.
Install Additional Safety Equipment If
Conditions Require
Laminate glass protection for the front, side or rear windows,
along with tempered glass, may also be recommended
depending upon particular site conditions.
Contact your DOOSAN distributor for available safety guards
and/or recommendations to prevent danger of getting hit by
objects that could strike the operator's cabin. Make sure that all
other work site crew members are kept well away from wheel
loader and safe from potential hazards.
Maintain Standard Safety Equipment in
Good Condition
Machinery guards and body panel covers must be in place at all
times. Keep well clear of rotating parts. Pinch point hazards
such as cooling fan and alternator drive belts could catch hair,
jewelry or oversize or very loose clothing.
Safety labels must be replaced if they are damaged or become
unreadable. Information on labels gives work crew members an
important safety reminder. Part numbers for each decal and
required mounting locations are shown on pages 1-2 through
1-4 of this section.
HAOA110L
Figure 11
HAOA100L
Figure 12