Doosan DL200, Руководство по эксплуатации и обслуживанию

Страница: 201 / 256

OP000509
4-57
Inspection, Maintenance and Adjustment
9. Rotate filter counterclockwise to remove it (Figure 91).
10. Clean filter head.
11. Grease filter gasket and gasket mating surface on filter
head.
12. Thread filter onto filter head. Tighten filter 1/2 turn after
filter gasket contacts filter head. Filter must be torque
to 1.6 - 2.1 kg•m (11.5 - 15 ft lb).
13. Fill transmission with fluid through transmission fill tube
(Figure 92).
14. Add fluid until fluid level reaches low mark on dipstick
(Figure 92).
15. Start engine. Idle engine for two minutes. Have a
person remain in the cabin.
16. With engine idling, have second person check
transmission fluid level again. Add fluid until level
reaches high mark on dipstick.
17. Idle engine until transmission fluid temperature reaches
80°C (176°F). Check fluid level with engine idling.
Level must reach high mark on dipstick.
NOTE:
If oil level is above top high mark on dipstick,
drain oil until level is at high mark.
NOTE:
If transmission cannot reach an operating
temperature of 80°C (176°F), then the oil level
must be below the high mark. Periodically check
oil level during the workday to ensure that oil
level does not rise above high mark on dipstick.
18. Check filter for leaks while engine is running.
FG002218
Figure 91
FG008085
Figure 92
Figure 93
HAOC280L