Doosan DL160, Руководство по эксплуатации и обслуживанию

Страница: 183 / 236

OP000756
4-53
Inspection, Maintenance and Adjustment
9. Rotate filter counterclockwise to remove it (Figure 80).
10. Clean filter head.
11. Grease filter gasket and gasket mating surface on filter
head.
12. Thread filter onto filter head. Tighten filter 1/2 turn after
filter gasket contacts filter head. Filter must be torque to
1.6 - 2.1 kg•m (11.5 - 15 ft lb).
13. Fill transmission with fluid through transmission fill tube
(Figure 81).
14. Add fluid until fluid level reaches low mark on dipstick
(Figure 81).
15. Start engine. Idle engine for two minutes. Have a person
remain in the cabin.
16. With engine idling, have second person check
transmission fluid level again. Add fluid until level reaches
high mark on dipstick.
17. Idle engine until transmission fluid temperature reaches
80°C (176°F). Check fluid level with engine idling. Level
must reach high mark on dipstick.
NOTE: If oil level is above top high mark on dipstick,
drain oil until level is at high mark.
NOTE: If transmission cannot reach an operating
temperature of 80°C (176°F), then the oil level
must be below the high mark. Periodically check
oil level during the workday to ensure that oil
level does not rise above high mark on dipstick.
18. Check filter for leaks while engine is running.
FG002218
Figure 80
FG013811
Figure 81
Figure 82
HAOC280L