Vehicle System
Disassembly & Assembly
65
7.
Remove bearing cup (8) from the hub (7).
8.
Remove seal, bearing cup and cone from the
bank of hub.
NOTE:
Check the condition of all seals, bearings
and components. If any parts are worn or
damaged, use new parts for replacement.
For purposes of assembly, lower the
temperature of the bearing cups before
installing into steer wheel (5). Use tooling (B)
to install bearing cups and seals.
9.
Pack bearing cones and lubricate the contact
surfaces of the bearing cups with
Multipurpose
Grease.
10.
Reverse the procedures and steps 2 through 9
to install the steer wheels and bearings.
11.
Adjust the steer wheel bearings as follows:
a.
Use tool (C) to tighten nut (5) to a torque of
135 N
•
m (100 lb
•
ft) while slowly rotating steer
wheel (5).
b.
Use tool (C) to loosen nut (5) completely.
c.
Use tool (C) to tighten nut (5) again to a
torque of 50 ± 5 N
•
m (37 ± 4 lb
•
ft).
d.
Insert a split pin (4) into a hole of knuckle and
then, bend over lock nut (5)
12.
Install wheel cap (3). Be sure to pack the cap
with Multipurpose Grease.
13.
Install steer wheel (2) and tighten the bolts (1).
14.
Remove tooling (A) and lower the lift truck.
