Dometic OPTIMUS 360, Инструкция по установке и эксплуатации

Страница: 51 / 96

5-15
EN
5.5.1
5.5.2
Planning
There are two color CANtrak displays available, as shown in table 5-4. All
displays are identical and can be used at any station.
Installation
Mount the display where it easily visible from the helm station. Consider
the following:
• Mount the display vertically, or within 60 degrees of vertical. Do not
mount it parallel to the deck unless the helm station is in an enclosed
wheelhouse where no water can accumulate on the face of the display.
• Ensure adequate ventilation around the unit.
• Ensure you can get to the rear of the unit for harness connections.
5.5 CANtrak display
DISPLAY
PART NO. FOR USE WITH NOTES
ED1700 Twin, triple, and
quad outboard
vessels Comes with harness CM21504 for
connection to both CAN1 and CAN2
networks
ED1800 Single outboard
vessels Comes with harness CM20030 for
connection to CAN1 only
Table 5-4.
NOTE
• A CANtrak display is required at the main helm station but is optional
at secondary control stations.
• A buzzer kit (HA5493) is required at any control station without a display.
• A mounting template is in Appendix A.
Figure 5-11.
Mount vertical to hull or wall Mount at an angle less than 60° DO NOT mount parallel to boat deck
<60° <60°