Dometic BUTTNER MT ICC 1600 SI-N, Инструкция по установке и эксплуатации

Страница: 20 / 140

20 4445103626
Installing the device
Mounting instructions
• MT ICC 1600 SI-N: The device can be mounted
horizontally or vertically. Do not mount the
device with the connectors facing up (fig.
3
,
page 5).
• MT ICC 3000 SI-N: The device can be mounted
vertically on the bracket, or on a horizontal sur-
face (fig.
4
, page 6).
For proper cooling, leave - at least - 100 mm free
space around all sides of the device (fig.
6
,
page 8).
The remote control should be installed in an acces-
sible place.
Mounting the device
A
MT ICC 1600 SI-N
1. Drill 4 holes according to the template
(fig.
1
, page 3).
2. Mount the device using the mounting screws.
MT ICC 3000 SI-N
1. Drill 7 holes according to the template
(fig.
2
, page 4).
2. Mount the bracket (fig.
5
, page 7, 2 ) using
the mounting screws (fig.
5
, page 7, 3 ).
3. Mount the device (fig.
5
, page 7, 1 ) on the
bracket (fig.
5
, page 7, 2 ).
Remote control
1. To flush mount the remote control, cut out the
mounting surface (fig.
8
, page 10). For sur-
face mounting, skip this step.
2. Drill 4 holes according to the template
(fig.
7
, page 9).
3. Connect the cable to the remote control
(fig.
c
, page 13).
4. To surface mount the remote control, install
the adapter (fig.
8
, page 10). For flush
mounting, skip this step.
5. Mount the remote control using the mounting
screws (fig.
8
, page 10).
Connecting the device
1. Lay all the necessary lines.
2. Plan the distribution and fuse protection of the
circuits carefully. The battery fuse should be
installed as close to the battery as possible.
The suggested distance is within 150 mm.
3. Secure all lines with strain relief clamps.
4. Connect the grounding cable (fig.
9
,
page 10)
5. Remove the lid:
– MT ICC 1600 SI-N: fig.
0
, page 11.
– MT ICC 3000 SI-N: fig.
a
, page 11.
6. Connect the input and output power cables
(fig.
b
, page 12) (MT ICC 3000 SI-N).
7. Connect the remote control (fig.
c
,
page 13).
8. Connect the battery temperature sensor
(fig.
d
, page 13).
A
9. Connect the battery cables to the device
(fig.
e
, page 14) (MT ICC 3000 SI-N).
10. Connect the cables to the battery (fig.
f
,
page 14) (MT ICC 3000 SI-N).
11. Install the lid in reverse order:
– MT ICC 1600 SI-N: fig.
0
, page 11.
– MT ICC 3000 SI-N: fig.
a
, page 11.
NOTICE! Damage hazard
Before drilling any holes, make sure that
no electrical cables or other parts of the
vehicle can be damaged by drilling, saw-
ing and filing.
NOTICE! Damage hazard
Always install the battery temperature
sensor. The charger automatically com-
pensates the charge voltages against
battery temperature for all types of lead
batteries.