18
DOLMAR GmbH
1
2
3
4
11 Crankcase / Crankshaft
11-03 Replacing the crankshaft / bearing
First push bearing on to the crankshaft, then
insert crankshaft with bearing (5) into the
case, "KS". Place gasket on centering pins.
Note: To dismantle or assembly the bearings,
always heat the crankcase to 100-120
°
C.
11-03 Dismantling the crankcase
After removing the 5 fixing screws, separate
the crankcase carefully by tapping with a
plastic hammer.
11-03 Mounting the crankcase
Tighten the 5 fixing screws with a torque of
10 Nm (see page 22).
11-03 Complete crankcase
The complete crankcase is divided into the
crankcase magnet side (2) "MS", and the
crankcase clutch side (1) "KS".
11-03 Removing the crankcase "MS"
To dismantle the magnet side (MS), unscrew
the 4 fixing screws (3) and the left lower
screw (4).
11-03 Mounting the bearing / crankcase
Heat the crankcase "MS" and fitt bearing into
the case.
Note: The bearings faces with its open side
to the crankshaft. Before installation moisten
the bearings with "Loctite 601".
5
Содержание PC-7312 HappyStart
Страница 23: ...23 DOLMAR GmbH Notice...