Dolmar PC-7312 HappyStart, Руководство по обслуживанию

Страница: 20 / 24

20
DOLMAR GmbH
PTFE
PTFE
1
5
3
6
4
8
9
7
11
12
13
17
16
10
2
13 Cutting attachment
13-02 Mounting the V-belt pulley
When mounting the pulley, make sure that the
shim 900.006.179 (6) is mounted between the
V-belt pulley and the ball bearing.
Note: The V-belt pulley is only fixed when the
cutting disk is mounted.
13-03 Replacing the drive axle
To remove the axle (7), the pressure disk (8)
and the V-belt pulley must be dismantled.
Note: when mounting the inner flange disk,
make sure that the spacer sleeve (9)
394.228.020 is mounted.
13-01 Replacing the pressure disc
Undo screw (1) and remove pressure disc.
Note: With the 25.4 mm (1") axle, the inner
flange is located behind the recess of the axle
(2). Remove axle and flange together.
13-02 Replacing the V-belt pulley
Block the V-belt pulley (3). To do this, push a
pin through the hole (4) in the V-belt pulley
into the housing. Remove screw (5).
13-05 Cutter guard holding attachments
When mounting, make sure that:
inside: outside:
- pressure ring (11) - housing (15)
- Teflon ring (12) - Teflon ring (12) -
- rubber part (13) - locking plate (16)
- rubber part (17)
15
13-04 Removing the complete pressure ring
Unscrew the 3 screws with springs (10), the
housing (15) and the pressure ring (11).
Note: the screws (10) have to be fitted in an
angle of 120
0 and are tightened with 10 Nm.