Doka Xclimb 60, Инструкция по сборке и эксплуатации

Страница: 34 / 128

34 999801002 - 02/2017
Anchoring on the structure User Information Automatic climbing formwork Xclimb 60
Positioning point with Positioning disk M30
(with no hole drilled through form-ply)
For special applications only, when it is not possible to
drill through the form-ply (e.g. where there are Doka
beams or formwork panel frame profiles directly behind
the positioning point).
How to mount:
➤ Fix the Positioning disk M30 to the form-ply using
28x60 nails (position as shown in drawing).
➤ Push the sealing sleeve all the way onto the Univer-
sal climbing cone.
➤ Screw the Stop anchor into the Universal climbing
cone, until it engages (up to the depth mark).
➤ Screw the Universal climbing cone onto the Position-
ing disk M30 and tighten it.
Tools needed:
▪
Reversible ratchet 3/4"
▪
Spanner for Universal climbing cone 15.0/20.0
▪
Extension 20cm 3/4"
▪
Box nut 50 3/4" (for Cone screw B 7cm)
▪
Reversible ratchet 1/2"
▪
Extension 1/2"
Pouring
➤ Before pouring, check all positioning points and sus-
pension points once again.
➤ Prevent the vibrator from touching the stop anchors.
➤
Do not place concrete from directly above the stop
anchors.
➤
Do not tie the stop anchors to the reinforcement with
binding wire.
These measures prevent the anchors from working
loose during pouring and vibration.
A Universal climbing cone 20.0 + Sealing sleeve K 20.0
C Stop anchor 20.0
D Depth mark
K Positioning disk M30
☞
Important!
It is not permitted to use the Positioning disk
M30 more than once in the same position, as it
cannot be fixed firmly and securely in the old
nail-holes.
K
98037-285-01
A
D C
▪
The axis of the universal climbing cone
must be at right angles to the surface of the
concrete – maximum angle of deviation: 2°.
▪
The universal climbing cone must be
embedded so that it is flush with the con-
crete surface.
▪
Tolerance for locating the positioning points
and suspension points: ±10 mm in the hori-
zontal and the vertical.
▪
The sealing sleeve must be completely
pushed onto the Universal climbing cone.
▪
The depth mark on the stop anchor must be
right up against the universal climbing cone
= must be screwed in to the full depth.
Mark the top edge of the formwork to make the
positions of the stop anchors easier to find
when the concrete has been poured.