Doka Xclimb 60, Инструкция по сборке и эксплуатации

Страница: 32 / 128

32 999801002 - 02/2017
Anchoring on the structure User Information Automatic climbing formwork Xclimb 60
Preparing the positioning point Positioning point with Cone screw B 7cm (with
hole drilled through form-ply)
How to mount:
➤
Fasten a packing plate (e.g. Dokaplex 15 mm) to the
form-ply (position as per project plan).
➤
Drill a diam. 30 mm hole in the form-ply (position as
shown in the project plan).
➤
Push the sealing sleeve all the way onto the Univer-
sal climbing cone.
➤
Push the Cone screw B 7cm through the form-facing,
screw it into the Universal climbing cone and tighten
it firmly.
➤ Screw the Stop anchor into the Universal climbing
cone, until it engages (up to the depth mark).
a ... 35 - 45 mm
Tools needed:
▪
Reversible ratchet 3/4"
▪
Spanner for Universal climbing cone 15.0/20.0
▪
Extension 20cm 3/4"
▪
Box nut 50 3/4" (for Cone screw B 7cm)
WARNING
➤ Always screw the Stop anchor into the Uni-
versal climbing cone until it fully engages
(i.e. up to the depth mark).
Not screwing the anchor sufficiently far into
the cone may subsequently lead to reduced
load-bearing capacity and to the failure of
the suspension point – resulting in injury and
damage.
➤ Use only the Cone screw B 7cm for the posi-
tioning point and suspension point (head of
screw is red )!
WARNING
Sensitive anchoring, suspension and connec-
tor components!
➤
Never weld or heat these components.
➤ Any components that are damaged or have
been weakened by corrosion or wear must
be withdrawn from use.
☞
▪
The axis of the universal climbing cone must
be at right-angles to the surface of the con-
crete – maximum angle of deviation: 2°.
▪
The universal climbing cone must be embed-
ded so that it is flush with the concrete sur-
face.
▪
Tolerance for locating the positioning points
and suspension points: ±10 mm in the hori-
zontal and the vertical.
▪
Universal climbing cones are supplied with
Sealing sleeves K. Every time the position-
ing cones are re-used , fit them with new
sealing sleeves first.
A Universal climbing cone 20.0 + Sealing sleeve K 20.0
C Stop anchor 20.0
D Depth mark
E Cone screw B 7cm
G Packing plate
98037-283-01
G A
E
D C
a