DOGA MDT Series, Инструкция по эксплуатации

Страница: 73 / 84

Instructions manual / MDT Series & MDTC38
60429 08/21 73
10.2 Fastening error by the pattern setting
Code Error message Description How to reset
300 Run time limit (Forward) Over time limit on parameter Check the parameter
301 Run time limit (Reverse) Over time limit on parameter Check the parameter
302 Model setting error Failure in Model programing Check the model process
303 Model cancel The Model process is canceled
304
Motor stall by loosening
failure Motor stall by loosening failure within
time limit on parameter
Check the parameter
305 Torque up before ramp up
Reach target torque before ramp up
speed.
Error reset
310
Time over in screw
counting
Over the time limit of screw counting
Check time limit in screw
count menu
311 Screw missing
When the work-piece moves out of the
working area without complete number
of fastening
Error reset
330 Min Angle error
Target torque reached before the
Min angle
331 Target angle setting error
Target angle setting is out of the range
[ AC/TM mode]
Set the Target Angle
332 Angle over
Target torque reached over the
Max angle
333 No torque complete
Operation stops before complete cycle
of torque up by releasing lever trigger
334
Engaging torque detection
fail The engaging torque is not detected in
time or angle limit
335 Converted torque error
Converted torque is out of torque limit
(%)
336 Over torque error
[AC/TM] Torque reached to the high limit
of torque capacity Change max torque
parameter
337 Torque up at free speed Torque up occur at Free speed
338
Thread tap max torque
error Over max torque during thread tap
advance function Check the Thread tap max
torque parameter
339
Thread tap min max
range error Thread tap setting min, max torque
range invalid Check the parameter
setting
400 Ethernet port fail Ethernet device IC initializing fail
401 Ethernet socket error
Ethernet communication error
related with socket
500 Over temperature Overtemperature over 80°C Auto reset under 80°C