DOGA MDT Series, Инструкция по эксплуатации

Страница: 35 / 84

Instructions manual / MDT Series & MDTC38
60429 08/21 35
7.5 Fastening settings
Parameters listed on A and B pages
for each Preset from 1 to 15
Preset selection
Type
Unit Range Initial
Description Control type
TC/AM : torque control/ angle monitoring
AC/TM : angle control/ torque monitoring
Torque target/ Max torque
Unit Range Initial
set up in controller Tool range
Description TC/AM : Target torque
AC/TM : Max torque
Torque limit / Min torque
Unit Range Initial
Torque limit (TC) %
Min torque (AC)
%
Set up in controller
0 ~ 100
Tool range
0
Description TC/AM : torque monitoring tolerance +/- % of target for fastening Ok
AC/TM : Min torque
Snug torque
Unit Range Initial
Set up in controller Tool range 0
Description In TC/AM : Point to start angle monitoring
In AC/TM : Point to control angle
Target speed
Unit Range Initial
rpm Tool range Auto
Description Target speed : Speed is changed by torque setting automatically.
To change to manual, Auto Speed must be Disabled in Controller menu
Target angle
Unit Range Initial
degree 0 ~ 20000 0
Description Target angle in AC/TM mode
Min angle
Unit Range Initial
degree 0 ~ 20000 0
Description Minimum angle to be OK in TC/AM mode