DOGA MDT Series, Инструкция по эксплуатации

Страница: 36 / 84

Instructions manual / MDT Series & MDTC38
60429 08/21 36
Max angle
Unit Range Initial
degree 0 ~ 20000 0
Description Maximum angle to be OK in TC/AM mode
Angle for Free speed
Unit Range Initial
degree 0 ~ 20000 0
Description Angle for Free speed
Free speed
Unit Range Initial
rpm Tool range 0
Description Manual setting speed. Shift back to the auto speed after the free angle
running
Soft start
Unit Range Initial
msec 0 ~ 300 0
Description Speed reach to the target in the setting time, Preset complement to
acceleration controller parameter
Seating point torque %
Unit Range Initial
% 10 ~ 95 50
Description In TC/AM : % of Target torque
Auto speed slow down to ramp-up speed for torque control
In AC/TM : to be set with same torque value as Snug torque,
in % of Max torque
Toque rising time
Unit Range Initial
msec 50 ~ 200 50
Description Time setting from seating point to the target
Ramp up speed
Unit Range Initial
rpm Tool range Auto
Description Speed after seating to the end of tightening
Torque compensation
Unit Range Initial
% 80 ~ 120 100
Description Individual torque tuning on each preset, saved in the controller
The torque output can be adjusted in the selected preset ONLY, it does not
influence other presets.
For details, please refer to chapter 9