DOGA MDT Series, Инструкция по эксплуатации

Страница: 48 / 84

Instructions manual / MDT Series & MDTC38
60429 08/21 48
Forward run time limit
Unit Range Initial
Sec 0 - 60 10
Description Run limit to forward rotation
–
It prevent the continuous running over the
preset time. The driver stops automaticaly at the preset time and
provides the pattern NG with error code
Reverse run time limit
Unit Range Initial
Sec 0 - 60 10
Description Run limit to reverse rotation
–
It prevent the continuous running over the
preset time. The driver stops automaticaly at the preset time and
provides the pattern NG with error code
Motor stall time
Unit Range Initial
Sec 0,1
–
0,5 0,2
Description Immediate stop when motor is stalled.- It prevent the continuous time
going against the motor stall for over heat protection
Error display reset time
Unit Range Initial
sec 0 ~ 10 1,0
Description Error display and reset after the below set time
Value 0 : manual reset with RESET button
Fastening OK signal time
Unit Range Initial
ms 0 ~ 500 200
Description Signal output time setting longer than 200ms which is factory setting.
Shorter time than factory setting doesn’t work..
Screw type
Unit Range Initial
CW - CCW CW
Description Set tightening rotation direction for each preset
Judged fasten minimum turn
Unit Range Initial
turn 0 ~ 5 0
Description Turns out of judgement
Fastening stop error
Unit Range Initial
YES - NO NO
Description NO : does not create any NG when the tool stops without fully tightening
by torque up.
Alarm sound control
Unit Range Initial
YES NO YES
Description Activation of noise alarm
–
stops when reset (timer or manual)
Torque calibration
Unit Range Initial
% 90 ~ 110 100
Description It is the master calibration for whole range of tool.
Saved in the tool memory and effective on another controller.
The F/R switch should be at Reverse position before writing the new
value.
For details, please refer to chapter 9