DoAll 3613-V5, Инструкция по эксплуатации

Страница: 30 / 32

26
ADJUSTABLE ANGLE SAW GUIDES
1. These saw guides allows to rotate the saw band a
set angle of 45° and 90° from the regular operating
position.
Adjustable Angle Saw Guides.
2. To adjust: (a) Pull the spring plunger out until it
disengages; (b) Turn the housing to the right until it
reaches the 45° preset stop until the spring plunger
snaps back into place: (c) Turn further to the right,
it will snap to the 90° preset stop. (d) Operate the
machine at band speeds under 1500 fpm (450m/
min).
DUST SPOUT
1. This option is located just below the worktable on
the right side of the machine frame near the lower
saw guide and attached to a collection system for
disposal of chips and other waste materials.
EXTRA WORK HEIGHT
1. The factory installed extra work height allows
maximum cutting capacity up to 30 inches (762.0
mm). Machines with this option have an auxiliary
post support, plus a slightly different frame weldment,
post guarding, and post elevating handwheel from
those shown elsewhere in this manual.
2. Roller saw guides are adjusted as follows:
• Select the rollers which match the width of saw band
to be used. Next: (a) Place one (1) back-up roller
(has a rear flange) and one (1) side roller in upper
guide block; (b) Place one (1) back-up roller and
one (1) side roller in the lower saw guide block in
opposite position of the upper guide; (c) Attach the
upper roller guide to the post and the lower roller
guide to the keeper block.
• Place the saw band over the upper and lower
bandwheels. Next: (a) Adjust the saw band tension;
(b) Loosen the roller lock screw; (c) Bring the
rollers toward the saw band by turning the eccentric
bearing shaft with a screwdriver. The rollers should
be just free enough to turn without moving the saw
band.
The bearngs wll overheat f the rollers are
too tght aganst the saw band. Conversely,
rollers that are too loose may cause the saw
band to wobble and affect cuttng accuracy.
• Tighten the roller lock screws to prevent the
eccentric shaft from turning and changing the roller
adjustment.
90° SAW GUIDE BRACKETS
1. These brackets permit cutting materials longer than
the machine's regular throat capacity. Install the
upper and lower brackets as shown. Then the saw
guide blocks are mounted to the brackets.
90° Saw Guide Brackets.
2. When these brackets are used, be sure to: (a) Install
the correct size saw guides; (b) Install the saw band
so that it is twisted 90°; when it passes through the
saw guide inserts; (c) Operate the machine at band
speeds under 1500 fpm (450 m/min).
OPTIONAL SAW GUIDES (Continued....)