DoAll 3613-V5, Инструкция по эксплуатации

Страница: 24 / 32

20
ACCESSORIES
The followng are accessores sometmes
used durng contour sawng operatons. A
DoALL sales representatve wll be happy to
advse you about the current avalablty of
any accessory.
DISC CUTTER
1. This attachment can be used to cut internal or
external circles from 2-1/2 to 30 inches (63.5 to
762.0 mm) in diameter. To set up the disc cutter:
• Place flat washers under the mounting screws. Then:
(a) Bolt the mounting bracket to the post; (b) Lower
the post until the upper saw guide is approximately
3/8 inch (10 mm) above the worktable; (c) Loosen
the fine adjustment and arm clamp bolts; (d) Move
the center pin to the approximate distance of the
radius to be cut; (e) Tighten the fine adjustment
clamp bolt.
Disc Cutter.
• Position the center pin so that it is perpendicular to
the saw band's cutting edge. To do so: (a) Place
a square against the tip of a sawband tooth; (b)
Loosen the vertical adjustment clamp bolt; (c) Line
up the center pin with the square's blade edge; (d)
Clamp the vertical adjustment clamp bolt.
• Make final radius adjustments with the fine
adjustment wheel. Then: (a) tighten the arm and
radius arm clamp bolts while making sure the center
pin is square to the table; (b) Adjust the disc cutter
for stock thickness by raising or lowering the post.
MITER NO. 2 CUT-OFF (Sde Mount)
1. To set up: (a) Place a combination square in the
worktable sawing slot to check the alignment;
(b) Set the bar for sawing at the desired angle.
It is important that the mitering bar contact the
worktable's surface evenly during use.
Miter No. 2 Cut-Off Option.
2. When not in use, this unit can be swung upward
and around on the slide rod so that it hangs down
below the worktable surface.
RIP FENCE
1. Square this fixture during installation so that it is in
line with the worktable sawing slot. When alignment
is correct, secure the adjusting screws in place with
the set screws under the the guide bar on the rip
fence casting.
2. Before attempting a long cut, check to see that the
saw band is not worn on one side. This will cause
stock to wander relative to the rip fence guide bar.
Rip Fence.
HEAVY WORK SLIDES
1. This unit features metal ball bearing slide bars
positioned to reduce friction between the worktable
and heavy stockpieces.