Switching device mode
for all modifications
1. Рower up the device. Depending on current settings saved in non-volatile memory, device starts
either in transmitter mode (green LED “LINK” is steady on or blinking), or in receiver mode (green LED
“LINK” is off).
2. If current mode is not correct for this device, switch the mode by pressing simultaneously
and holding for 4 sec the “SETUP” and “RESET” buttons. The new mode is saved in non-volatile memory,
and the device reboots with new settings. Configuration of the network, formed in transmitter mode,
is preserved when the device is switched in receiver mode and back.
3. After setting the desired mode of operation, configure device in the receiver or transmitter mode
(see above).
Operation
RadioGate Plus devices start their normal operation in a few seconds after they have been powered up.
Device always operates based on last saved settings. Viewing RadioGate Plus settings does not affect
normal operation until any of the settings have been saved. When changes are saved, the device applies
the new settings immediately, without having to power it down. The status of each DMX port
is indicated by the corresponding status LED.
In the input mode, port status LED is steady on if there is valid DMX input signal or flashes slowly
the DMX input signal is invalid or absent. In the output and loop modes, port status LED is steady
on when there is no data for output and blinks when new DMX data are transmitted (updated).
In the off mode, port status LED is off.
Current status of each port can be controlled through the web interface.
Receiver mode
1. When the power is turned on, the receiver waits for a connection request
from the transmitter. At the same time, the STATUS status LED (red) is constantly on.
2. When the connection to the transmitter is established, the communication LED
is constantly on LINK (green). DMX512 data received from the transmitter is output
to the output connector.
3. Pressing the RESET button (for DC version) disconnects the receiver from
the transmitter and rebooting the device. After rebooting, the receiver goes
into standby mode.
7
RadioGate Plus
