Installation
1. Visual inspection of the device to make sure that
damage caused by transportation.
2. Install the supplied antennas and connect necessary
DMX cables.
3. If the device will be installed on the truss, screw
the mounting kit.
4. Connect the power cable of the AC 100-250V device to the power outlet
and configure devices.
Device configuration
1. Unscrew the screws and remove the upper lid.
2. Set the device operation mode using sections 1 and 2 DIP-
switch:
3. For DC models, select a wireless subnet using sections 3 and 4 DIP
switches:
4. For models set advanced device parameters
using sections 7 and 8 of the DIP switch:
5. Install the lid and tighten the screws.
Section 7
Subnet mode
On
Fixed subnet for receiver (default)
Off
Auto subnet for receiver
Section 8
Setting
On
DIP-switch setting (default)
Off
Setup via web interface
Section 1
Section 2
Device function
On
On
Transmitter mode
On
Off
Selecting a mode using the buttons (default)
Off
Off
Receiver mode
Section 3
Section 4
Wireless Subnet Number
On
On
0
On
On
Off
Off
1
Off
Off
2
3
5
RadioGate Plus
Warning!
Before mounting and power up, it is
necessary to verify protective earthing
and cable connections.
