Wireless network configuring
(receiver)
The device is ready for further network configuration.
Wireless network configuring
(transmitter)
1. Рower up the device. “LINK” LED (green) must be steady on or blink.
2. Turn on all receivers that are needed to connect to device, placing them at a minimal distance
from the device. If all receivers work properly, they light up “STATUS” LED (red). Turn off all receivers,
which should not be included in the configured network.
3. On transmitter device, press and hold for 1 second the button “SETUP” on port 1. Then, transmitter
searches free (not connected) receivers for 10 seconds; during this process LEDs “LINK” (green)
and “STATUS” (red) blink fast.
4. Upon completion of search process, verify the correctness of created network: on the transmitter
LEDs “LINK” (green) and “STATUS” (red) blink slowly, on all connected receivers LED “STATUS”
blink slowly (red).
5. If your network configuration is not correct, switch off and on the device, and after rebooting
the device, repeat steps 2-4.
6. If your network configuration is correct, press and hold for 1 sec the “SETUP” button to save created
network configuration in non-volatile memory of the transmitter. Device restarts and resumes
normal operation with the new network configuration.
7. For dual channel devices repeat steps 2-6 to configure second channel.
8. Transmitter device and configured network is ready to work.
6
RadioGate Plus
