DMX signal timing
– sets the parameters of the output DMX signal for all ports
Break
MaB
Data slots
Pause
from 4 to 1000 µs
from 4 to 1000 µs
1 to 512
from 0 to 10000 µs
Advanced port settings
– settings for advanced features for each port
Src. timeout
Trigger/XFade unv. protocol
Trigger/XFade unv. number
Trigger/XFade control channel
Loop. unv. protocol
Loop. unv. number
Triggers/alarms -
Trigger and Static scenes setup (only "Capture scene" Action is applicable
for RadioGate Plus series)
Input
Mode
Delay, ms
Status
Action
Trigger/Sensor input
Operating mode (disabled, trigger/alarm sensor normally open/closed)
Delay for triggering in milliseconds
Current status of input (open, closed, active, alarm)
Save the current state of all DMX-ports as scene to recall on trigger activation
DMX line terminator
– enables (selected) or disables (cleared) termination resistor between
D+ and D- wires of DMX line on each port.
Options
– enable/disable device features.
Universe source timeout, in seconds
XFade/Trigger control universe protocol
XFade/Trigger control universe number
XFade/Trigger control channel
Loop back universe protocol
Loop back universe number
12
RadioGate Plus
To save the changes in main settings, click
“Save settings”
.
To restore default values of main settings, click
“Set default”
.
To reset to the current saved values of main settings, click
“Reset”
.
