DMP Electronics 734N-WIFI, Инструкция по установке и программированию

Страница: 9 / 44

Digital Monitoring Products, Inc. | 734N-WIFI Installation and Programming Guide 5
The 734N-WIFI provides a Form C (SPDT) relay for controlling locks and other
electronically-controlled barriers. The three relay terminals marked NO C NC allow you
to connect the device wiring to the relay for module control.
Use an additional power supply to power magnetic locks and door strikes. See Figures
2 and 3 for typical magnetic lock and door strike wiring.
The Form C relay draws up to 35mA of current and contacts are rated for 10 Amps
(resistive) at 12/24VDC. When connecting multiple locks to the Form C relay, the total
current for all locks cannot exceed 10 Amps. If the total current for all locks exceeds
10 Amps, problems may arise and an isolation relay may be needed. See the Isolation
Relay section for information.
2
WIRE THE ELECTRONIC LOCK
PROG
J2
RED RED
KYPD IN
J4
J1
DATA
XMT LED
WIEGAND
READ LED
RELAY
ON
NC C NO
GRN YEL RED
Model 333
Supressor
Normally Closed
–
+
Magnetic Door Lock
12/24VDC
Power Supply
Figure 2: Typical Magnetic Lock Wiring
PROG
J2
RED
J1
DATA
XMT LED
WIEGAND
READ LED
RELAY
ON
NC C NO
GRN YEL RED
Model 333
Supressor
Normally Open
– +
DC Door Strike
12/24VDC
Power Supply
Figure 3: Typical Door Strike Wiring