DLM-4 ZONE
DLM-4 ZONE
Controller
Controller
32
33
9. Troubleshooting
9. Troubleshooting Continued...
Some of the most common issues or problems can be found within
this section. Before returning the unit for service, please consult the
troubleshooting points below, additional information can be found
online at
www.dutchlightinginnovations.com
The DLM-4 Zone Controller is
connected to power, but it
does not seem to be working
/ no display
Check the low-volt power
supply is plugged in properly
to the DLM-4 Zone Controller.
After setting up the DLM-4
Zone Controller, the fixtures
are still not being turn on or
controlled.
Each ballast must be manually
switched to External (DLM-4
Zone Controller) control. Verify
the selector switches on the
ballast are correct.
The 315 watt fixtures cannot be
dimmed. However, they can be
turned OFF if the temperature
reaches the “Off At” setpoint.
Within each Zone settings,
you can select which
temperature sensor you want
to “assign” to that zone. Verify
the Sensor setting is correct.
Make sure the temperature
sensor is not receiving direct
HID light which would increase
the temperature reading.
The Zone does not seem
to be controlled by the
temperature sensor correctly.
The temperature display
within one or more zones
does not seem to be correct,
reading high.
Power was interrupted to the
unit, and now the lights will
not turn on.
There is a 15-minute time delay
after a power failure to prevent
the lamps from hot-starts.
The dimming function does
not work for my 315 watt
fixtures.
PROBLEM
RESOLUTION
WARNING:
DO NOT
allow theDLM-4 Zone Controller to be
exposed to water or excessive heat.
DO NOT
open or attempt
to repair or disassemble the controller, as there are no user-
serviceable parts inside. Opening the controller will void the
warranty.
If the DLM-4 surface is dirty, wipe it with a dry towel.
The DLM-4 operates under natural ventilation conditions.
AVERTISSEMENT:
N’
exposez
PAS
le régulateur de zone DLM-4
à de l’eau ou à une chaleur excessive.
NE
l’ouvrez
PAS
,
NE
tentez
PAS
de le réparer ou de le démonter, car il ne contient aucune
pièce réparable par l’utilisateur. L’ouverture du régulateur
entraîne l’annulation de la garantie.
Si la surface du DLM-4 est sale, essuyez-la à l’aide d’un chiffon
sec. Le DLM-4 fonctionne sous des conditions de ventilation
naturelle.
Содержание DLM-4 ZONE
Страница 1: ...DLM 4 ZONE Controller ...
Страница 19: ...www dutchlightinginnovations com ...