©2013 DJI Innovations. All Rights Reserved.
10 |
Charger &Battery
Instruction
*If the charger is in Max Circuit Power condition, the
charge circuit will be decided by 20W. For example, when
2A or 3A is selected for the 3S battery, the Charge Circuit
is only 20w/11v=1.8A actually.
Battery
：
LiPo(2200MAH-20C
－
11.1V)
Charger
AC Input: 100-240V
Charge Circuit
：
1A/2A/3A Selectable
Current Drain for Balancing: 200mA
Circuit Power
：
MAX 20W
LED Indicator
Charge
Status
LED
Ready to Charge
CC Mode
CV Mode
Charge complete
Cell LED
Charging
Discharging
Charging
1.
Insert the AC power cord into the charger and AC cord into a
wall socket (100-240V). The charge status LED will flash green.
2.
Select the battery type LiPo and the charging current 2A.
3.
Connect the battery main charge lead to battery socket and the
battery balance wire to the 3S balance socket.Make sure the red
lead to the red battery socket, and the black lead to the black
battery socket
4.
Start charging. The charge status LED and the 1S/2S/3S cell LED
will glow constant red.
5.
When the charge status LED glows constant red, it is charging in
CC (Constant Current)mode and LED glows green & red blink
is in CV (Constant Voltage) mode.
6.
When the cell LED is flashing, it is discharging for balancing.
7.
When the battery is fully charged, the charge status LED will
glow constant green.Unplug the battery from the charger.
Make sure to use the battery after fully charging.
When the charger is in CV mode (with green and red LED blinking), the battery is over 80% charged.
Please use the battery according to the attached sticker.
Use the Protection Clip to keep the leads of the battery socket untouched, in order to avoid short circuit.
DJI VISION App
DJI VISION App is installed for remote control of Camera Setting, Capture and Recording, Camera Pitch
Control, Aircraft Yaw Control, and GPS Assistant Orientation.
