©2013 DJI Innovations. All Rights Reserved.
23 |
3.
Click “Info” to view your current software version, if there has updates you can down and install.
4.
Click “Upgrade” to view your current firmware version, if there has updates you can down and
install.
5.
Wait until the Assistant software shows “finished” and power cycle. Up to date OK.
Note:
If firmware upgrade failed, the system will enter waiting for firmware upgrade status automatically,
please try again with above steps.
Autopilot System LED Description
System Status
LED Flashing
System start and self-check
IMU abnormal data or need advanced
calibration*
Warm up after power on
The aircraft is moved or bias of sensors too big
Compass error too big, need recalibration.
Transmitter (TX) signal lost, enter the FailSaf
e.
TX stick(s) mid point error too big
Low voltage alert or other abnormal alert*
(e.g. Configuration error, TX data error, En
able low voltage protection without PMU, S
N error or Compass abnormal work.)
Record forward direction or home point
Control Mode Indictor
Manual Mode**: None
ATTI. Mode:
( stick(s) not at center
)
GPS Mode:
( stick(s) not at center
)
IOC Mode**:
( stick(s) not at center
)
GPS Signal State Indicator
（
GPS/Compass Module is necessary
）
GPS Signal is Best(GPS Satellite number > 6): None
GPS Signal is Well(GPS Satellite number = 6):
GPS Signal is Bad (GPS Satellite number = 5) :
GPS Signal is Worst (GPS Satellite number < 5):
*You can figure out the error by connecting the autopilot system to the Assistant Software.
**Should be enabled on the Assistant Software.
Specification
General
Features
Aircraft and camera integration, less weight,
