dIXEL
Operating Instructions
cod. 1592017410
1592017410 XLH360 GB r1.0 15.04.2005.doc
XLH360
6/16
1.
Push twice the corespondent key: the setting value of the current phase (dripping or running) will be displayed.
2.
Modify it using the
UP
and
DOWN
keys
3.
Confirm the value using the corespondent key: temperature (SET TEMP), humidity (SET %RH) or remaining time (CLOCK).
NOTE: the changes made will be memorised. So the next cycle will start with the new values.
8.
THE DISPLAY
C
F
SET
SET
%RH
To display and modify target temperature set point. (
SET TEMP
) for the running (St1)and
the dripping (StG) phase.
To display and modify target humidity set point (
SET %RH
) of the running (SH1) phase; in
programming mode it selects a parameter or confirm an operation.
In programming mode it browses the parameter codes or increases the displayed value.
If oA2=ESt hold it pressed for 3s to start a extraction cycle
To start a manual defrost: hold it pressed for at least 3s.
In programming mode it browses the parameter codes or decreases the displayed value.
Switch ON and OFF the light, if present (oA1=lig)
Start
: to start the cycle
Clock
: to set the duration of the dripping (dri), running (on) and stopping (off) phases
Switch ON and OFF the instrument.
KEY COMBINATIONS
+
To lock and unlock the keyboard
+
To enter the programming mode.
+
To exit the programming mode.
8.1
ICONS AND SYMBOLS
Each LED function is described in the following table.
