© Copyright 2003-2019 Dive Lab® Inc. All rights reserved.
This Guide is made available for the express use of owners and users of the Dive Lab XLDS systems.
This information is subject to periodic updates and changes. Always check the Dive Lab web site for the latest versions.
Document XLDS Guide – Section Four A
Revised September 30, 2019
43
SECTION FOUR A: RDC REPAIR / MAINTENANCE / OVERHAUL
Figure 77 ICS Manifold Assembly, Part #4XL002
The manifold has three 3/8”-24 LP ports, used for
inflator whips, and one ½”-20 port, used for the
helmet or full face mask supply whip.
Figure 78, shows the hose configuration for a full
face mask (green hose), for helmets the center
hose is the same 34” long 3/8” gates hose, which
is used on all XLDS systems. To the right and left
of the green hose, is the BC inflator hose, and the
dry suit inflator hose. If the inflator hose is not
needed, a 3/8”-24 (small bore scuba) plug is
installed.
Maintenance consists of removal from ICS,
inspection, cleaning, replace O-rings and reinstall
on ICS regulator.
Figure 78 ICS Manifold Hose Routing
1.
Remove all inflator hoses and helmet/full face
mask hose.
2.
Remove ICS manifold assembly from ICS
regulator. Figure 77.
3.
Using a 5/32” Allen wrench, remove any
remaining port plugs.
4.
Check all threaded components for signs of
galling. Replace any components, which show
any signs of galling, or damaged threads.
