Disty disty-guard, Руководство по эксплуатации

Страница: 19 / 28

disty-guard, operating instructions
To avoid disturbing noises during transmission, it is advisable to switch off the microphone of
the transmitting device.
Configuration via microphone
To configure a disty-guard without programming station, it is possible to adjust the
parameter sent by DTMF tones through the microphone. This may be necessary if the base
station uses an AC, which differs from the default setting.
As a prerequisite the
disty-guard must be unsubscribed.
The function is activated by pressing the alarm button. Both LEDs are illuminated.
Now the device will record the DTMF-tones via the microphone for the next 30 seconds.
For example, the setting of an AC = 0627 would be as follows: ** 9 5 0 6 2 7 #.
To generate those sounds, there are various possibilities. This can be done with a tone
generator, a telephone, mobile phone or a PC - program. In the case of a telephone a
connection is made to any subscriber. Then place the
disty-guard near the earpiece or
speaker of the phone, push the button on the
disty-guard
and now select the above-
described combinations of numbers on the push button at the telephone.
The successful programming is indicated by a positive acknowledgment tone.
If you want to change other parameters, this procedure must be repeated accordingly.
Special location request ( default: disabled )
For certain pabx, the current location of the user/ terminal is determined by a short call. This
process is carried out periodically by a PC.
Not to disturb the normal operation, the caller's number ( CLIP ) is compared to a
programmed one. In case the call comes from the PC, the connection will be released
immediately. The use informed about this process through the brief flash of the green LED.
Battery warning as SMS ( ASCOM only, default: disabled )
If the battery reaches its low limit of capacity, a corresponding text message is sent to the
control panel ( format, see
SMS – messages
).
Personal Alarm ( default: disabled )
If this feature is enabled ( locator options
→
Function 24.6. ), the function of the key is
changed. The disty-guard responds as the alarm button at a ASCOM - handset:
long press
→
'Test - alarm', two short pressures
→
'User - alarm'.
The messages of the alarm button and the shock sensor will be transmitted as SMS -
Page 19 of 25