Disty disty-guard, Руководство по эксплуатации

Страница: 7 / 28

disty-guard, operating instructions
Putting into operation
Charge the
disty-guard
in the disty-guard charger ( Charger station / CS ) until the red
LED turns off.
Subscription
There is an in-built algorithm to accelerate the login process in such a way that the disty-
guard
begins by searching for the strongest base station. It is therefore of paramount
importance to ensure that the terminal device is logged-in in the proximity of a base station!
The preset authentication code ( AC ) is 0000.
The disty-guard is prepared through the following procedure. The process functions only if
the device is not subscribed. See chapter on “Factory setting”.
The device is plugged into the CS. Press the key within the next 5 seconds and wait 10 sec
for the green LED to light up. Now let go off the key.
The function has now been activated. The green LED begins to flash. This indicates that the
disty-guard
is searching for the base station that is ready for subscription.
The DECT base station is activated for the subscription process. Ensure that no other base
station / DECT system has activated subscription readiness.
You will hear a “Beep” after successful subscription and the device will restart to accept the
data. The subscription process is thus completed and the
disty-guard
can be removed
from the charger station. The device begins to search for the base station and register itself.
It switches to the “Stand-by state” ( = idle locked ) after successful synchronization.
The green LED will now flash up briefly once in every 10 seconds.
ASCOM system / multi - cell system
Normally, the disty-guard is subscribed as described in the previous chapter. The system
has already been activated for subscription. The system administrator enters the new
terminal device into the system.
Is the
disty-guard
required to function in a specific facility? If yes, please follow the
following instructions.
Page 7 of 25