Dish Network VQ4510, Руководство пользователя

Страница: 4 / 181

Safety
vi
15
The receiver is still connected to the AC power whenever it is plugged into a live power
outlet, even if it is turned off using the remote control or front panel buttons.
16
No flame sources, such as lit candles, should be placed on the equipment.
17
The apparatus shall not be exposed to dripping or splashing, and no objects filled with
liquids, such as vases, shall be placed on the top of it.
18
Operate the receiver using only the type of power source indicated on the marking label.
Unplug the receiver power cord by gripping the power plug, not the cord.
19
Do not overload wall outlets or extension cords; this can result in a risk of fire or electrical
shock.
20
Never insert objects of any kind into the receiver through openings, as the objects may
touch dangerous voltage points or short out parts. This could cause fire or electrical shock.
21
Do not locate the antenna near overhead light or power circuits, or where it can fall into
such power lines or circuits. When installing the antenna, take extreme care to avoid
touching such power lines or circuits, as contact with them can be fatal.
22
Do not attempt to service the receiver yourself, as opening or removing covers may
expose you to dangerous voltage and will void the Limited Warranty. Refer all servicing to
authorized service personnel.
23
Unplug the receiver from the AC power outlet before cleaning.
24
Do not place the receiver in an enclosure such as a cabinet without proper ventilation.
25
Do not install the receiver in any area where the temperature can be less than 40°F or
more than 113°F. If the receiver is cold to the touch, do not plug it in immediately. Let it sit
unplugged at room temperature for at least 45 minutes before plugging it in.
26
Use an outlet that contains surge suppression or ground fault protection. During an
electrical storm or when the receiver is left unattended and unused for long periods of
time, unplug the power cord from the wall outlet, disconnect the lines between the receiver
and the antenna, and disconnect the Ethernet cable. These actions provide additional
protection against damage caused by lightning or power line surges.
27
Tighten all of the coaxial cable connections only by hand. If you use a wrench, you may
overtighten the connections and damage your equipment. Damage caused by
overtightening is not covered by the Limited Warranty.