Dish Network VQ4510, Руководство пользователя

Страница: 166 / 181

6. Verify “Scan” is highlighted.
Press
SELECT on your remote.
The scan will begin and may take up to several minutes to complete.
3. Point your receiver’s remote at the front of the receiver and press
SAT and then press 5(&25' .
When a number appears in the box, verify “Continue” is highlighted.
Press
SELECT on your remote.
The
Portable Antenna Setup
screen will display.
The receiver will update software for DISH programming.
This step may take 20-25 minutes.
7. The receiver will reset and the
Mobile Antenna Setup
Screen will
appear. Repeat steps 4-6 to initiate a second scan.
The antenna will scan a second time.
When the scan is complete, the “
Acquiring Signal
” message will
display. Acquiring the signal may take up to 5 minutes to complete.
8. After your receiver has acquired the signal, it is ready to be
activated. To activate service call ',6+ .
After your receiver is activated, the electronic program guide will
download. This may take up to 5 minutes to complete (potentially
longer if an external hard drive is connected).
7KLVFRPSOHWHVWKHVHWXSIRUQHZUHFHLYHUV
),5677,0(86(
,I\RXUUHFHLYHULV
1(:$1'81$&7,9$7('
FRPSOHWHWKHVHVWHSV¿UVW
<RXRQO\KDYHWRFRPSOHWHWKHVHVWHSVRQHWLPH
$IWHUFRPSOHWLRQ\RXFDQXVH
67$1'$5'23(5$7,21RQWKHIURQWRIWKLVJXLGH
5. Highlight the state you are currently in from the state menu.
Press SELECT on your remote.
4. Use the arrow buttons on your remote to highlight the letter group
WKDWLQFOXGHVWKH¿UVWOHWWHURIWKHVWDWH\RXDUHFXUUHQWO\LQ
Press
SELECT on your remote.
3
6
7
8
5
Lay the unit on a soft,
non-scratching surface,
and apply the (3)
rubber feet.
$Q\WDOOREMHFWVFDQEORFNWKHVDWHOOLWHVLJQDO
'2127$33/<)((7
,)<28:,//%(522)
02817,1*7+(
$17(11$81,7
2. Place KING Tailgater in position and make connections
in the following order: A , B , and C .
1
B
A C
When you plug in the receiver, the green power light should illuminate or
begin cycling on and off (if not, check AC connection).
Wait for the green light to turn solid. This may take up to two minutes.
If it does not turn solid, power on your receiver using the front panel
POWER button. (On “z” models, this is located behind the door panel.)
4. Turn on your TV. In your TV’s input selection menu, choose the
input that matches the connection from your receiver.
3OXJLQ
UHFHLYHU
last!
'RQRWRYHUWLJKWHQFRD[FRQQHFWLRQV'RQRWSXOORQFRD[
2